| // On x86_64, the kernel does not provide the faulting address for dereferences |
| // of addresses greater than the 48-bit hardware addressable range, i.e., |
| // `siginfo.si_addr` is zero in ASan's SEGV signal handler. This test checks |
| // that ASan does not misrepresent such cases as "NULL dereferences". |
| |
| // REQUIRES: x86_64-target-arch |
| // RUN: %clang_asan %s -o %t |
| // RUN: export %env_asan_opts=print_scariness=1 |
| // RUN: not %run %t 0x0000000000000000 2>&1 | FileCheck %s --check-prefixes=ZERO,HINT-PAGE0 |
| // RUN: not %run %t 0x0000000000000FFF 2>&1 | FileCheck %s --check-prefixes=LOW1,HINT-PAGE0 |
| // RUN: not %run %t 0x0000000000001000 2>&1 | FileCheck %s --check-prefixes=LOW2,HINT-NONE |
| // RUN: not %run %t 0x4141414141414141 2>&1 | FileCheck %s --check-prefixes=HIGH,HINT-HIGHADDR |
| // RUN: not %run %t 0xFFFFFFFFFFFFFFFF 2>&1 | FileCheck %s --check-prefixes=MAX,HINT-HIGHADDR |
| |
| #include <stdint.h> |
| #include <stdlib.h> |
| |
| int main(int argc, const char *argv[]) { |
| const char *hex = argv[1]; |
| uint64_t *addr = (uint64_t *)strtoull(hex, NULL, 16); |
| uint64_t x = *addr; // segmentation fault |
| return x; |
| } |
| |
| // ZERO: SEGV on unknown address 0x000000000000 (pc |
| // LOW1: SEGV on unknown address 0x000000000fff (pc |
| // LOW2: SEGV on unknown address 0x000000001000 (pc |
| // HIGH: {{BUS|SEGV}} on unknown address (pc |
| // MAX: {{BUS|SEGV}} on unknown address (pc |
| |
| // HINT-PAGE0-NOT: Hint: this fault was caused by a dereference of a high value address |
| // HINT-PAGE0: Hint: address points to the zero page. |
| |
| // HINT-NONE-NOT: Hint: this fault was caused by a dereference of a high value address |
| // HINT-NONE-NOT: Hint: address points to the zero page. |
| |
| // HINT-HIGHADDR: Hint: this fault was caused by a dereference of a high value address |
| // HINT-HIGHADDR-NOT: Hint: address points to the zero page. |
| |
| // ZERO: SCARINESS: 10 (null-deref) |
| // LOW1: SCARINESS: 10 (null-deref) |
| // LOW2: SCARINESS: 20 (wild-addr-read) |
| // HIGH: SCARINESS: {{(20 \(wild-addr-read\))|(60 \(wild-jump\))}} |
| // MAX: SCARINESS: {{(20 \(wild-addr-read\))|(60 \(wild-jump\))}} |
| |
| // TODO: Currently, register values are only printed on Mac. Once this changes, |
| // remove the 'TODO_' prefix in the following lines. |
| // TODO_HIGH,TODO_MAX: Register values: |
| // TODO_HIGH: = 0x4141414141414141 |
| // TODO_MAX: = 0xffffffffffffffff |
