/*
 * Copyright (C) 2022 The Android Open Source Project
 *
 * Licensed under the Apache License, Version 2.0 (the "License");
 * you may not use this file except in compliance with the License.
 * You may obtain a copy of the License at
 *
 *      http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing, software
 * distributed under the License is distributed on an "AS IS" BASIS,
 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
 * See the License for the specific language governing permissions and
 * limitations under the License.
 */

syntax = "proto2";

package perfetto.protos;

// Network tracing data source that records details on all packets sent or
// received by the network.
message NetworkPacketTraceConfig {
  // Polling frequency in milliseconds. Network tracing writes to a fixed size
  // ring buffer. The polling interval should be such that the ring buffer is
  // unlikely to fill in that interval (or that filling is an acceptable risk).
  // The minimum polling rate is 100ms (values below this are ignored).
  // Introduced in Android 14 (U).
  optional uint32 poll_ms = 1;

  // The aggregation_threshold is the number of packets at which an event will
  // switch from per-packet details to aggregate details. For example, a value
  // of 50 means that if a particular event (grouped by the unique combinations
  // of metadata fields: {interface, direction, uid, etc}) has fewer than 50
  // packets, the exact timestamp and length are recorded for each packet. If
  // there were 50 or more packets in an event, it would only record the total
  // duration, packets, and length. A value of zero or unspecified will always
  /// record per-packet details. A value of 1 always records aggregate details.
  optional uint32 aggregation_threshold = 2;

  // Specifies the maximum number of packet contexts to intern at a time. This
  // prevents the interning table from growing too large and controls whether
  // interning is enabled or disabled (a value of zero disables interning and
  // is the default). When a data sources interning table reaches this amount,
  // packet contexts will be inlined into NetworkPacketEvents.
  optional uint32 intern_limit = 3;

  // The following fields specify whether certain fields should be dropped from
  // the output. Dropping fields improves normalization results, reduces the
  // size of the interning table, and slightly reduces event size.
  optional bool drop_local_port = 4;
  optional bool drop_remote_port = 5;
  optional bool drop_tcp_flags = 6;
}